Method 2505

Fufuryl Alcohol by GC/FID

This method is used for the determination of furfuryl alcohol. The sample is collected on Porapak Q sorbent tubes, desorbed in acetone and analyzed using GC-FID. The working range is 4 to 150 ppm (0.01 to 0.05 mg/m³) for a 6 L air sample. NOTE: This method revises NIOSH Method S365.

(NIOSH Issue 2: 15 August 1994)


No Obligation Quotation for Analytical Services

If you would like us to provide a quote for laboratory analysis, just provide us with as much information as you can about your project (the more, the better) and we'll provide you a quote via email. As you are searching or browsing our Analytical Guide, you'll see the Request-A-Quote icon... just click on it to start the request process.

Method Data

Hold Times, Preservatives, Preps, Collection, Analytical & Documentation
Holding Time:   At least 1 week from sampling to analysis if kept at 25°C
Preservatives:   Store at 25°C.
Required Preps:   Solid sorbent tube: Porapak Q, 150 mg/75 mg, 8.5cm x 6mm OD x 4mm ID
Collection Method:   Solid sorbent tube: 3 - 25 L @ 0.01 - 0.05 L/min.
Analytical Methodology:   GC/FID
Documentation:   2505

Analyte List*

Analyte Formula CAS Number Detection Limit
Furfuryl Alcohol

* The analytes and detection limits listed for each method represent the typical detection limits and analytes reported for that particular method. Keep in mind that analyte lists may vary from laboratory to laboratory. Detection limits may also vary from lab to lab and are dependent upon the sample size, matrix, and any interferences that may be present in the sample.